overview

Isotherm Danfoss BD50F 12/24V Air Cooled Compressor

Danfoss compressor complete with condenser, tubing and quick connect couplings supplied as a replacement part for Isotherm refrigeration units. The SBC39325DA compressor includes a fan. Although they are factory pre-gassed, the complete system must be evacuated and re-charged with ozone friendly R134A refrigerant upon replacement.

The BD50F is next in line to the BD80F compressor.  Like the smaller BD35F (below) and larger BD80F (above), the BD50F uses an electronically communicated permanent magnet brush-less DC motor.  The advantages of this approach are small size and variable-capacity.  As with its predecessors, the BD50F does require the use of an electronic power module.  Like all electronics, the power module is extremely reliable as long as it is properly installed and does not overheat.  (To prevent overheating use our Danfoss Power Module Cooling Fan Kit.) 

NOTE:  The BD50F compressor requires a Power Module to run.  The same power module is used for 12vdc and 24vdc systems.  The module must be purchased separately from the compressor.  There are three types of modules to choose from, the standard power module (010-1175), the Adaptive Energy Optimizing (AEO) module (010-1176), or the High Start module (010-1178).  The AEO module is more energy efficient as the compressor will always adapt its speed to the actual cooling demand.  The High Start module provides additional starting torque  and is more dependable in turning the system on. 

Options:

• Danfoss Electronic module is NOT INCLUDED
• SEG00002DA - 12/24 Volt Electronic Control Unit - suits BD35F and BD50F

Downloads:

• Quick Connection Coupling Product Change

specification

Downloads:

• Danfoss 101N0500 - ACDC Module Information Sheet
• Service Notes for Installation of AC/DC Module