overview

Isotherm CR195 Inox Stainless Steel Upright 2 Door Fridge/Freezer 381716 (1195BB1NK)

130L Fridge Plus 65L Freezer - 12 to 24 Volt - LH Door Hinge

Includes Stainless Steel Flush Mounting Frame

Twin Danfoss Compressor Units with Individual Thermostat Control

12-24 Volt flush mounted cabinet style refrigerator with Stainless Steel doors and trims that are well suited for the marine environment.

The Isotherm CR195 is a two-door stainless steel fridge-freezer. A CR130 refrigerator built on top of a 65 litre freezer. It is equipped with a fan cooled compressors and the refrigerator is equipped with an inner light and a vegetable bin. The freezer has extra strong insulation and the whole unit comes with a flush mounting frame.

Features:

• Food preparation compliant stainless steel case
• Flush mounted - no protrusion into galley area
• Positive, flush closing mechanism
• Hermetic fan cooled compressor
• Contoured single piece plastic liner
• Adjustable shelves
• Internal light
• Low voltage cut off
• Radio interference suppression
• Internal rotary thermostat
• Utilises R134A ozone friendly refrigeration gas

Downloads:

• Isotherm Cruise Marine Refrigerator Brochure
• Isotherm Cruise & Elegance Manual
• Isotherm Cruise 195L INOX Silverline spare parts list

Other Cruise 195 Options Available:

• 1195BB7MK - Cruise 195L Inox With 3-Side Flush Mounting Frame AC/DC Only RH Hinge Position
• 1195BB7NK - Cruise 195L Inox With 3-Side Flush Mounting Frame AC/DC Only LH Hinge Position
• 381717 - Cruise 195L Inox With 3-Side Flush Mounting Frame DC Only RH Hinge Position
• 381716 - Cruise 195L Inox With 3-Side Flush Mounting Frame DC Only LH Hinge Position
• 381686 – Cruise 195L Grey Line AC/DC (1195BB7CA)

specification

Ventilation:
It is very important that the compressor/condenser unit is well ventilated and that cold air can enter at the bottom, pass behind the fridge and warm air can leave at the top in the area where it is mounted. The natural flow of air from below and upwards behind the fridge can be increased by arranging  ventilation openings at the rear. Make sure there is a free area of 15 - 23 sq.in. below and behind the refrigerator to allow ventilation air to pass behind from below. (see diagram below).

Electrical Connections:
When connecting the refrigerator electrically, it is important that following points are considered:
Always use cables of suffi cient area. The area in the following table should be regarded as a minimum. * Always connect the refrigerator directly to the battery or to the battery main switch on the plus circuit. Do not connect it via the boats own control panel or other diversions as this can cause a voltage drop in the power supply. Use the included fuse holder with a 15A fuse. Use 7.5A fuse in a 24 volt system. The fuse shall be mounted on the plus cable.
*Connect the red cable to the positive (+) terminal and the black to the negative (-) terminal. Use tab type terminals for the connection to the electronic unit and other cable connectors of sufficient size for the cable size selected. * Do not connect the refrigerator direct to a battery charger. The battery charger must be connected to the battery.

Battery Voltage (Shut Down) Sensor:
To protect the batteries from becoming completely discharged, a battery voltage sensor switches off the compressor automatically at the following levels:

Wire Dimensions:
The correct wire gauge  and type must be used.